Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.

First time visiting? Here are some places to start:

  1. Looking for a certain topic? Check out the categories filter or use Search (upper right).
  2. Need support? Ask a question to our Community Support category.
  3. Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
  4. Be respectful, on topic and if you see a problem, Flag it.

If you would like to contact our Community Manager personally, feel free to send a private message or an email.

Tapped hole call-out dimension precision

bill_danielsbill_daniels Member Posts: 246 ✭✭✭
I note that changes to whole drawing precision also affects tapped hole call-out dimensions.  For example 2-digit precision (.12) results in a two-digit tap drill diameter which is a round-off error.  This can make it difficult to select a tap drill.  I think it would be better to keep drill diameters to 3-digits regardless of whole-drawing precision changes.

Comments

  • PeteYodisPeteYodis Moderator, Onshape Employees Posts: 287
    @bill_daniels We have an improvement to be able to set the precision and tolerance for each parameter in a hole callout.  It's on our radar to deliver.  
Sign In or Register to comment.