Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
Set Preferenences
Colm_Rev
Member Posts: 9 PRO
When doing certain tasks, say extrude remove for example, I tend to use the "up to next" option more than any other option.
I have to select this option each time.
When mirroring, I tend to mirror a feature, again I have to select this option each time.
There are many examples of this this type of additional selection.
In many software programs there is an option to set preferences.
May I add this feature to the improvement request list please.
Thanks
Colm.
I have to select this option each time.
When mirroring, I tend to mirror a feature, again I have to select this option each time.
There are many examples of this this type of additional selection.
In many software programs there is an option to set preferences.
May I add this feature to the improvement request list please.
Thanks
Colm.
Tagged:
5
Comments