Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.

First time visiting? Here are some places to start:
  1. Looking for a certain topic? Check out the categories filter or use Search (upper right).
  2. Need support? Ask a question to our Community Support category.
  3. Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
  4. Be respectful, on topic and if you see a problem, Flag it.

If you would like to contact our Community Manager personally, feel free to send a private message or an email.

Is there a way to fix this constraint without breaking part?

carlos_berdealcarlos_berdeal Member Posts: 76 ✭✭
On sketch 1 of my part, I was told I needed to fix this constraint. When I do I seem to break a good portion of the rest of the whole part. Is there a way to do it without killing the part? I tried and I lost the bottom section of the part with a bunch of sections turning red. I am new to this so I hope I did not start on the wrong foot.


Comments

Sign In or Register to comment.