Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
Loft "all guides should intersect with profile boundary
henri_bellanger
Member Posts: 4 ✭
I am designing a boat hull, it has a smooth curve (created with a spline) at the bottom and a sharp corner at the top.
I want to loft between the 3 faces i have created but the two upper line to not intersect with the opposite far side, is there a way to resolve this?
as you can see some funky geometry going on at the top there, when it should just be two straight lines and a hard curve
https://cad.onshape.com/documents/965d00636b4cff3c831b75f4/w/a429fce9c34442e3707ebcc9/e/98777789e5ab75d5236c4a8c?renderMode=0&uiState=6926f3d3d4504ac113985b3f
Best Answer
-
Matt_Shields
Member, Onshape Employees Posts: 843 PRO
It sounds like what you're trying to do could be done with two lofts.
0
Answers
It sounds like what you're trying to do could be done with two lofts.
+1 to @Matt_Shields comment
The underlying reason is that any single guide curve must consist of G1 (tangent) connected edges
cheer mate, thanks!