Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
Remove Fillets from standard content
john_mcclary
Member, Developers Posts: 3,935 PRO
As trival as it sounds, there is no need for fillets on lock washers in standard content.
This is a widely used component and can appear many times in a drawing.
It would seem these 2 little fillets could end up accounting for half of the rendering time to 2D drawing views.
If I am wrong let me know.
But I would like to see the extra level of detail removed if possible.
I haven't checked every Standard content model, but those should be simplified if possible too.
Lock washer is on it's way to be a lag monster.
Thanks
This is a widely used component and can appear many times in a drawing.
It would seem these 2 little fillets could end up accounting for half of the rendering time to 2D drawing views.
If I am wrong let me know.
But I would like to see the extra level of detail removed if possible.
I haven't checked every Standard content model, but those should be simplified if possible too.
Lock washer is on it's way to be a lag monster.
Thanks
Tagged:
5