Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
Sketch constraints
göte_berggren
Member Posts: 4 ✭✭
in General
In the Sketch dialog, checking the box of "Show constraints" does not work.
If it is replaced by the "Constraint manager" it should be removed for selection.
0
Comments
Works fine for me. If there aren't any constraints, it will show nothing.
Can you share a document?
Yep, I confirm there is an issue. It does not show constaints in all situations. I check the box and constraints show up, but only for a short period of time, then they vanish one by one, until I uncheck the box and check it again.
Sounds like something to send to support. I wonder if it's browser specific?