Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.First time visiting? Here are some places to start:
- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
Older Improvement Requests...
Thought I would go through some of the much older IR's to vote on and thought I would share some thoughts.
This says it's "completed", but I beg to differ based on the request. I want to be able to select a Part(s) and specifically show their Mates via the Parts List or Graphics area RMB.
So I voted for @Tony_C_ idea below...
This is becoming an annoyance/hindrance not being able to select a face that's been sectioned to drag and move Parts based on their mates.
We still need commonly used Port Holes such as NPT standard holes added without the need for custom FS that still isn't available, but this idea below is marked completed with 27 votes.
This request for Assembly Level Pattern (marked completed with 27 votes) is marked complete with the addition of the Replicate command, but I think most users would rather have the Derived Pattern functionality/idea from @john_mcclary below (See discussion in link for more details)
This is still a BIG limitation for adding Hole Callout dimension's within a drawing.
@owen_sparksbrings up a small but noticeable UI behavior I've noticed too; it's a UI annoyance to be sure that could be improved.
I've noticed the lack of "Auto-Advance" with adding a Mate Connector Between Entities too. There may be others, but these workflows can be improved.