how to

Probably easy, but trying to figure it out - I'd like to apply a draft angle to the disks in the attached screenshot - what do you use as the neutral plane in this case? or how do you create one? Ideally I would use the base of where they hit the main shaft as the start and apply the taper radially. My "hard way" solution…

Im trying to add angled holes to the base of a rectangular project that will hold 8mm rod as legs. There will be 4 legs, one at each corner and each angled out to the corners at about 20 degrees. I found a picture of a coffee table with roughly what I mean. The only way I've found to do this is to use move face on a…

Hello, total newb here who is just learning Onshape from the ground up. What I want to do: I am trying to design what amounts to a fan housing. I have the outer ring done and am trying to add cross pieces so that I can mount the fan itself (imagine a circle with an 'x' across it). How I am trying to do it: I am sketching…

Hi all, I've been fiddling with the loft feature and having some issues. Below is a pic of the part i'm working on. The issue is that I get a "guide curve" that I don't want (straight line between the sketches) I've seen this with different CAD systems too and usually the added guide curves are enough to get rid of it. Any…