Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
nick_papageorge_dayjob PRO
Reactions
-
Re: "Same same, but different" or WTF with arks
How can center arc work with 3 points from a geometry standpoint? (if the 3 points are constrained). The center point and the first point will define the radius. The third point if it was arbitrarily… (View Post)1 -
Re: "Same same, but different" or WTF with arks
For your main arc shape in your original question, you could have had the main sketch have a single arc, instead of 4 offset arcs. Then use thin extrude to make your shape. Then use thicken (new) to … (View Post)1 -
Re: Folders in Parts List in Part Studio?
https://forum.onshape.com/discussion/comment/126507#Comment_126507 This thread was started 6 years ago, and since then, folders have been added in specific places. In a part studio, parts cannot be p… (View Post)1 -
Re: Why is this sketch not fully defined?
https://forum.onshape.com/discussion/comment/126501#Comment_126501 CAD is about impossible to pick up fumbling around, like you might be able to do in a word processor. Do the training built into OS … (View Post)1 -
Re: Why is this sketch not fully defined?
Put the dim to the flats of the box, not to the tangent points of the radii. That is the design intent 99.9% of the time. Then, put a separate dim for the radius. Set both radii equal to each other. … (View Post)1
