Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
Answers
The face box is the face to extend or trim.
IR for AS/NZS 1100
Disclaimer-I'm really bad at naming things ie... billy2
opExtendSheetBody: Sheets
opEdgeChange: Edges
I thought sheets should be surfaces, but that's too confusing. The fact the edges extends & trims means those names are out, same for sheets. You really should launch these through Neil Cooke. they're really good. Put your name in them & contact info as a comment.
Do you like the way the opEdgeChange UI populates?
IR for AS/NZS 1100
I have now named the features as follows:
opExtendSheetBody: Extend Surface
opEdgeChange: Change Edge
opCreateOutline: Project Body
IR for AS/NZS 1100