Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
Dimensioning a Sweep and a Loft
alexander_visakay
Member Posts: 17 ✭✭
in Drawings
Hello. I am trying to dimension this hook that I drew. On the left is a sweep where the dia is consistent and I am unable to put a radius dimension onto the drawing. The bottom right side is lofted and tapers down and I can not dimension that side either. Thanks for any help
0
Comments