Extrude did not regenerate properly. Selected offset is too large, decrease the value.

mark_bowman

I am new to Onshape, and I am working on the wheel tutorial. When I perform step 19 of 23 for Extrude 5, I get the message of "Extrude did not regenerate properly. Selected offset is too large, decrease the value.". I have looked at my drawing and have not found any open areas. Help with this problem would be greatly appreciated.
The link to the drawing is:
https://cad.onshape.com/documents/826f27b9578402200a3000d6/w/15f056327b22d033754f1fdc/e/3b27baab84ef6c4b830cb1d3

NeilCooke

Change the direction of the extrudes - you are extruding away from the selected faces

mark_bowman

Neil, I set the Extrude parameters the same as you are showing, but I still get the same error message. Any other ideas?
The link to the wheel exercise is below.
https://cad.onshape.com/documents/826f27b9578402200a3000d6/w/15f056327b22d033754f1fdc/e/3b27baab84ef6c4b830cb1d3

Prachi

Mark
I opened your document and found there is no face or sketches to extrude. The blue highlighted box.