Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.

First time visiting? Here are some places to start:
  1. Looking for a certain topic? Check out the categories filter or use Search (upper right).
  2. Need support? Ask a question to our Community Support category.
  3. Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
  4. Be respectful, on topic and if you see a problem, Flag it.

If you would like to contact our Community Manager personally, feel free to send a private message or an email.

DXF Export has ? where there should be -

ConorConor Member Posts: 2 PRO
Using deviation tolerance, Instead of + on top and - on bottom in exported DXF file, there is + and ?. Hole callout was not used as holes were created using extrusion


Comments

  • NeilCookeNeilCooke Moderator, Onshape Employees Posts: 3,960
    Hi @Conor - is that viewed in Onshape (exported then imported) or another software? If Onshape shows it like this can you please open a support ticket.
    Director, Technical Services, EMEAI
Sign In or Register to comment.