Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
Is there a way to fix this constraint without breaking part?
carlos_berdeal
Member Posts: 76 ✭✭
in General
On sketch 1 of my part, I was told I needed to fix this constraint. When I do I seem to break a good portion of the rest of the whole part. Is there a way to do it without killing the part? I tried and I lost the bottom section of the part with a bunch of sections turning red. I am new to this so I hope I did not start on the wrong foot.
0
Comments
I do see an underdefined line here:
If you try and remove it, things do break.
Is this your problem?
if so, then just make these two lines equal
I noticed your geometry was wavy in some areas
I don't know if what is showing above, is what you were looking for.
But if you would like to avoid that wavy curve, then take a look at the doc below
https://cad.onshape.com/documents/671e6db5467c816bddbb5526/w/6b71db144e3327baad821b5e/e/497e004668472fc8531c8fd0