Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
Are there limitations for "thin extrusions"?
Aleksey_Rybalnik
Member Posts: 5 PRO
in General
Hello, I have created a sketch that represents the z-fold of my very thin material (20um) with the final length of several meters long. However, I have not been able to successfully extrude the entire sketch as a single part. I have tried a sweep first, then "thin extrusion", but the result was the same. In the end, I was able to create several extrusions and then "combining" all of the new parts into a Composite Part. However, when I use the Composite Part in the Assembly, it shows as a "Parts Studio" and prevents from further configuring the assembly. I must have over 100 features in the sketch, as the "curve/surface analysis" tool failed to analyze the whole sketch.
0
Answers