mates
Discussion List
-
Replaced parts won't mate in assembly
Hi all, I have a set of parts that I replaced with parts (same geometry, just different properties) from another assembly. The mates that previously applied to the original parts broke, and when I try to fix them with the new instances, I now get told that they are over-defining the assembly. Does anyone have experience…
-
How do you establish a mate between an axis and a plane
Hello everyone! I want to establish a mate connection so that the shaft below pushes the pin up and down. Is it possible? Best regards
-
Miura Fold in Onshape
Hello. I'm interested in creating an assembly in Onshape that can move like the Miura Fold pattern. I've tried making the parallelograms with rounded edges, and mated the edges with pin slot mates and one revolute mate to keep all of the parts together, but it's not fully constrained. Here's what I have so far. Any ideas…
-
Odd mate behavior in multilevel assembly.
Referring to the picture below. Of the 4 blue elbows 2 (1 and 4) of them are in the wrong position. You can see that they are part of the Cooling System sub-assembly. If I attempt to drag the elbows about in the workspace then they will not move. If I go through to the Cooling System sub-assembly the parts are in the…
-
placing mates in context
Is it bad practice to place mates in-context that depends on the ghosted part? Will it create a circular reference or does it suffice to avoid updating?
-
copy mate features possible?
NeilCooke the context menu on a Mate has a copy in it. How can it be used? P.S. Is it possible to edit a suppressed feature or do you have to unsuppress it first?. The reason is that I think its easier to edit it when its suppressed and you can move it to a temporary workarea.
-
Assemblies - Replicated parts orientation
Is there any way to make the replicate tool in assemblies align to specified orientations different from the replicated part? I've tried mating to non-round pockets and faces (features with obvious directionality) to try to force the replicated parts to face the direction I'd like them to face, but they always orient in…
-
Mate motion propagation/inherit through assembly levels
I have the following assembly structure Top-Assembly Sub-Assembly 1 (stationary) Sub-Assembly 2 (rotating relatively to Sub-Assembly 1) With Sub-Assembly 2 having the following structure Sub-Assembly 2 Sub-Assembly 3 (stationary) Sub-Assembly 4 (sliding relatively to Sub-Assembly 3) Now on top-Assembly level I have one…