-
Creating custom supports for 3d printing
Pretty straight forward with what I'm trying to do. I've already created one custom support, but I'm having an issued creating one on the brow of the helmet because the helmet itself and nose piece are intersecting with where the support should be. I tried projecting the brow to a sketch on the base plane, but am having…
-
I cannot get this shape right
I am not a newbie and have a some experience with Onshape, but I am running into issues getting this shape right. It is a rectangular shape with 2 straight and 2 curved sides. The bottom is where I am running into issues. The way I am trying to do it, is giving me unnecessary facets: I just want the bottom edge to run…
-
How to use expressions to define a dimension relative to another?
I have these two holes that I want to create, as shown below. The one on the right is in the middle of that surface (I used midpoint). I am struggling to define the dimension highlighted. I would like it to be the same distance as the other hole is from the right wall. Is there any way to make this happen?
-
How to paste Mesurements into different Part Studios?
heyo, So my problem is that I want to use the measured variable "globaly" in the document (i.e adding it to variable studio). Or to explain it on my curent problem (but had this multiple times): I'm designing something that has a slide door in it. So in the first Part studio I design the contraption, the backet so to…
-
Can't figure out how to make a tapered symmetrical open donut
I'm trying to find a way to make something like the attached image. The closest I could get is the other attached image (basically a circle, revolved symetrically, with chamfered ends (I couldn't chamfer more than 0.9mm before it wouldn't work — why is that?). The profile should smoothly taper from the thickest, about 2mm…
-
is it posable to move parts between part studios
-
Animation possibility
Hello, I don't ask questions a lot here but I found it necessary since it might save me some time. I'm getting towards the stages where I start animating stuff for my project and I'm not quite experienced with animations hence my question: The movement here is a bit complicated, maybe even too complex to animate in…
-
How to change the "Top View" Hotkey?
Hey folks, How do I change the hotkey for Top View? I can't find it in the hot-key change menu in Profile > Settings > Keyboard shortcuts. Is there some other menu for hotkeys that I don't know about? I've searched the forums and google, but can't find anything other than "you can change shortcuts!" from here:…
-
Looping through a Const list
Hi All, I have a list of values in a const list 'arraySize" and wanted to know if it is possible to have a value loop through them. My example is below, and the value I would be looking to show is: var myDiameter = 13 * millimeter var actualDiameter = "This should be the value from the the const table, e.g. 9/16″ (14.28mm)…
-
Cant see "Monitor Part Studio1" FeatureScript
Hi, I´m currently learning how to create FeatureScripts. If I press "Monitor Part Studio 1" in the top right corner, nothing is happening. In the tutorial there is a textbar popping up ("FeatureScript notices"): Is there anything I clicked wrong? Thanks in advance.
-
Making the front of a Diamond Play Button
I have a basic shape for a diamond play button, i was just wondering how I would create the raised-ness of the top of the play button... Any ideas? I have the basic lines drawn on a sketch plane, I just do not know how to extrude lines...